Series OFS O-Ring Face Seal Fittings are bubble-tight, zero-clearance fittings designed specifically for use in gas fill plant manifolds up to 6,000 PSI. Constructed of high-strength Naval Brass for high pressure service and to allow for continuous remakes of the face seal connection.
The zero-clearance fitting design allows for easy removal and replacement of system components without the need to disassemble other connections on the line. Supplied cleaned for Oxygen Service. Compatible with other O-Ring Face Seal type fittings including the Generant MV Series -2FS valve port.
- O-Ring Face Seal for Reliable, Leak-Free Connection
- Zero-Clearance Design for Easy System Maintenance — Remove and Replace Components Without Disassembling Other Connections
- Naval Brass Construction — High Pressure Service and Continuous Remakes
- Rated to 6,000 PSI (413.7 bar)
- Supplied Cleaned for Oxygen Service (Standard)
- Compatible with Other O-Ring Face Seal Type Fittings
- Compatible with Generant MV Series -2FS Valve Ports
- Available in Tailpiece, Nut, and Bulkhead Configurations
- Maximum Operating Pressure @ 100°F: 6,000 PSI (413.7 bar)
- Temperature Rating: -65°F to 375°F (-54°C to 190°C) — seal material dependent
- Leakage: <0.01 SCCM Helium at 6,000 PSI
- O-Ring Sizing: -2 connection uses -210 O-ring | -3 connection uses -212 O-ring
- All fittings constructed of Half-Hard Naval Brass, ASTM B21
- Tailpieces supplied with O-ring installed in groove
- Bulkhead fittings supplied with bulkhead nut installed
- Note: Buna-N seal not recommended for Oxygen Service
- Other materials available — consult factory
